Project

General

Profile

Test Beam Shift Bulletin Board » History » Version 41

« Previous - Version 41/97 (diff) - Next » - Current version
Alexandre Pereira Sousa, 07/04/2019 04:05 PM


Test Beam Shift Bulletin Board

Welcome to the NOvA Test Beam shift bulletin board! Look here for relevant information about the current status of operations.

Current Run Coordinator: Alex Sousa (617-682 6064)

Current On-Call Experts:

  • Day: Teresa Lackey (608-443-9109)
  • Night: Andrew Sutton (919-619-8866)

Current Running Conditions

Secondary Beamline Tuning and Beam Halo Studies

ECL entries with details of the studies done:

All plots going into: http://novadaq-test-master.fnal.gov/beamtuning/

Running conditions and run numbers found in: https://docs.google.com/spreadsheets/d/1kUI1HRDhCQWzimxRcGTcgThaRhS2VXPaaW3TXKHmLLo/edit?usp=sharing

Excellent Evernote summary of studies by Dung Phan:

Current DAQ Configurations

Beamline

Two conditions:

on: TOFPROMPT MWPCOFF SWYDGATE
off: DIGBUSY

on: TOFUS MWPCOFF SWYDGATE
off: DIGBUSY

Detector

  • Configuration: TestBeam_AllTrigs_HalfDetector

Current Digitizer Configurations

  • Digitizer rate: 2.5 GHz

Important Notes

  • Every time a beamline run ends, or at the end of your shift, please add it to the table at Commissioning runs.
  • The detector is now interlocked with environmental monitoring, so if there is an environment alarm, the HV and LV power supplies will shutdown, preventing damage to APDs and FEBs. However, you should keep an eye on the "PLC Dry Gas & Water" synoptic display, in case the HVAC freezes or the water chiller trips. If the HVAC stops cooling MC7 (most likely triggering an environment dew point alarm), the water chiller should be stopped, to prevent condensation on the water lines flowing through the detector, until the HVAC is recovered. If the water chiller stops working (most likely triggering an Inlet APD Water Temp alarm), a picture of the front panel in the water chiller should be taken, and the water chiller should be stopped until it can be recovered. More information is found under: Environment Emergency Procedures

Temporary Things To Be Aware Of!

  • If the VNC crashes, it can be reopened from the icon on the desktop. This will pop up a terminal and open up the display. If the terminal doesn't close on its own, please close it yourself otherwise the VNC may not start properly.
  • We are still confirming the beamline TDU is working as expected. Things may not be too smooth with this.
  • The beamline DQM is still a little flaky, and we're working on it. Try restarting a few times if it crashes, it normally works. If you can't get it to work, and you're concerned about the quality of the data, contact the on-call expert.