ShiftBulletinBoard » History » Version 49

Version 48 (Stephen Magill, 02/26/2014 01:33 PM) → Version 49/1035 (Stephen Magill, 02/27/2014 08:04 AM)

|[[NOvA_Shifts|Main Page]]|[[What to do while on shift]]|[[ShiftHowTo|How To ...]]|[[DAQ Trouble Shooting Guide]]|

h1. Shift Bulletin Board - Thursday, 02/27/14 Wednesday, 02/26/14

> h2. Instructions for turning off and on Low voltage and High Voltage are included in the Shift Handbook - shifters please read and be able to respond to requests from Ash River

> h2.
On P3, if alarms occur on FEBs (false alarms), call Ron Rechenmacher.

> h2. After an Ash River power outage or water leak, *(color:red) AFTER* after power is restored and *(color:red) BEFORE* before cooling is started, call Evan Niner (Timing, DAQ expert) if any boxes on the TDU Delay display are red.

> h2. When starting OnMon and Event Display on FarDet, a new popup box appears that asks you to pick which disk to use - select "datadisk-3" for both.

> h2. TDU Info - *{color:red} IMPORTANT* for Run Start when running both Partitions 2 and 3 at the same time

> > h2. For Partition 2 and 3 : They are both running on timing chain 2. A TDU allows only 1 connection at a time from the TDU Control. After a Partition 2 run gets started, press "disconnect" on the TDU Control gui for that partition. The LED will turn yellow. Then start the run on Partition 3, which will now be able to communicate to the TDU (on Timing Chain 2) and issue a sync. With both P2 and P3 runs going, only one TDU Control will be connected (it doesn't matter which one). If either P2 or P3 needs a sync, press the sync button (red bar) on the connected TDU Control. Both partitions will see the sync. If you suspect timing problems on Partitions 2 or 3, call Evan Niner (number on call list under DAQ Expert or TDU Timing)

> h2. For FarDet
> > h2. Partition 1 (diblocks 1,2,3) should be running constantly, especially if there is beam
> > Partition 2 (diblocks 4,5(except DCM-2-05-12),6,DCM-2-07-06) should run constantly unless commissioning work is being done (weekday daytime hours)
> > Partition 3 (diblocks 8,9s,10,11) should be run on night shifts only

> h2. List of DAQ Named Configurations to use in FarDet runs :
> > h2. Partition 1 - *{color:blue} FarDetGlobalConfigP1*
> > Partition 2 - *{color:blue} FarDetGlobalConfigP2*
> > Partition 3 - *{color:blue} FarDetGlobalConfigP3*

> h2. For NDOS, use *{color:blue} InitialGlobalConfig* for Partition 2 running

|[[NOvA_Shifts|Main Page]]|[[What to do while on shift]]|[[ShiftHowTo|How To ...]]|[[DAQ Trouble Shooting Guide]]|