Project

General

Profile

ShiftBulletinBoard » History » Version 43

« Previous - Version 43/1041 (diff) - Next » - Current version
Stephen Magill, 02/22/2014 07:59 AM


Main Page What to do while on shift How To ... DAQ Trouble Shooting Guide

Shift Bulletin Board - Saturday, 02/22/14

When starting OnMon and Event Display on FarDet, a new popup box appears that asks you to pick which disk to use - select "datadisk-3" for both.

TDU Info - IMPORTANT for Run Start when running both Partitions 2 and 3 at the same time

For Partition 2 and 3 : They are both running on timing chain 2. A TDU allows only 1 connection at a time from the TDU Control. After a Partition 2 run gets started, press "disconnect" on the TDU Control gui for that partition. The LED will turn yellow. Then start the run on Partition 3, which will now be able to communicate to the TDU (on Timing Chain 2) and issue a sync. With both P2 and P3 runs going, only one TDU Control will be connected (it doesn't matter which one). If either P2 or P3 needs a sync, press the sync button (red bar) on the connected TDU Control. Both partitions will see the sync. If you suspect timing problems on Partitions 2 or 3, call Evan Niner (number on call list under DAQ Expert or TDU Timing)

For FarDet

Partition 1 (diblocks 1,2,3) should be running constantly, especially if there is beam
Partition 2 (diblocks 4,5(except DCM-2-05-12),6,DCM-2-07-06) should run constantly unless commissioning work is being done (weekday daytime hours)
Partition 3 (diblocks 8,9s,10,11) should be run on night shifts only

List of DAQ Named Configurations to use in FarDet runs :

Partition 1 - FarDetGlobalConfigP1
Partition 2 - FarDetGlobalConfigP2
Partition 3 - FarDetGlobalConfigP3

For NDOS, use InitialGlobalConfig for Partition 2 running

Main Page What to do while on shift How To ... DAQ Trouble Shooting Guide