Project

General

Profile

Setup Detector Auto-Sync

Here is how you set the far detector to automatically synchronize the DCMs every 10 minutes:

First, in words:

1. Go to the TDU Manager:
2. Click on "Config" and then on "Enable Expert Mode":
3. Select the "Timing Control" tab:
4. Check the "Enable" box and set the time to 600 s (= 10 min):
5. After you enabled the automatic sync, you will see countdown on the bottom right for the next sync:
6. When you are all done, disable the expert mode again so no accidental changes are made:

Now with pictures :

1. Go to the TDU Manager:

2. Click on "Config" and then on "Enable Expert Mode":

3. Select the "Timing Control" tab:

4. Check the "Enable" box and set the time to 600 s (= 10 min):

5. After you enabled the automatic sync, you will see countdown on the bottom right for the next sync:

6. When you are all done, disable the expert mode again so no accidental changes are made: