Running DAQ Interface » History » Version 214

Version 213 (John Freeman, 01/09/2017 05:05 PM) → Version 214/223 (John Freeman, 01/09/2017 05:16 PM)

John Freeman, Jan-9-2016:

This wiki page used to contain instructions on how to run the classic DAQInterface application for the 35ton experiment. Since 35ton, DAQInterface has been modified, and is now in general use across all experiments. Getting it installed and running takes only a couple of minutes; see for how to do this. Note that the instructions assume that you're working with the artdaq-demo DAQ software package rather than protoDUNE's lbne-artdaq DAQ software package; consequently the following modifications to the instructions on the new DAQInterface wiki apply

* After checking out artdaq-utilities-daqinterface, cd into it and run "git checkout protodune"; this will make it easier to modify (e.g., it replaces references to artdaq-demo with references to lbne-artdaq, etc.)

* Make sure you've already got the 35ton configuration repo checked out - i.e., that you've run "git clone" in the directory where you wish to install lbne-daq-config
* Modify ./rc/control/ so that the "config_dirname" variable at the top of the "get_config_info_base" function refers to the 35ton configuration repo

Besides this, following the instructions on the DAQInterface wiki will get you running with lbne-artdaq's ToySimulator.