- Table of contents
- GENIE at FNAL
- Official GENIE site
- GENIE development work at Fermilab
GENIE at FNAL¶
This is the wiki page for GENIE work being done at FNAL
Official GENIE site¶
The full GENIE project is hosted at hepforge: http://genie.hepforge.org
GENIE as a UPS product¶
The GENIE code is available from
genie.hepforge.org, but needs to be compiled in a manner consistent with other products it depends on (ROOT, LHAPDF, etc) and with any framework it might be used within (e.g. ART). Many of the FNAL experiments use UPS to share these installations.
In order to use GENIE for event generation one must have generated cross-section splines for any and all desired combinations of neutrino an flavor and nuclear isotope. Versions of these spline files that are adequate for the FNAL experiments are distributed via UPS.
- UPS products genie_phyopt and genie_xsec
- List of available pre-calculate spline sets: https://cdcvs.fnal.gov/redmine/projects/nutools/wiki/GENIE_Configuration_Files
Flux handling for GENIE and FNAL experiments¶
Event generation for realistic experimental setups relies on a non-trivial characterization of the neutrino flux. The
GNuMIFlux code exists to handle many of the data products of the NuMI flux simulations. The
GSimpleNtpFlux format is a simplified ntuple containing the bare minimum of data for neutrino rays; such files can be derived from
GNuMIFlux interpretations of the beam simulations evaluated at a given detector location.
Future "flux" file are to be migrated to using the
dk2nu ntuple format: https://cdcvs.fnal.gov/redmine/projects/nusoftart/wiki/Dk2nu
In many cases
genie event generation will occur as a stage embedded in the
art framework. Information on that can be found as part of the
nutools project ( https://cdcvs.fnal.gov/redmine/projects/nutools/wiki ).
Reading GENIE native format files¶
GENIE development work at Fermilab¶
This section is intended for the local developers and not end-users.