## IQ-R4 » History » Version 4

« Previous - Version 4/9 (diff) - Next » - Current version
Jiangang Hao, 07/09/2012 09:37 AM

# IQ-R4¶

Requirements:

• TO.2: The delivered PSF from the telescope, instrument, and other factors exclusive of the site seeing will be no greater than 0.55 arcsec FWHM (DES-doc-806-v25).
• R-18: The PSF FWHM in each of the r, i, and z bands should, over all exposures and over the survey area, have a median of less than 0.9”. Moreover, for 95% of the survey area, there should be at least one exposure in each of these bands for which the mean PSF FWHM is 0.9” or smaller (DES-doc-20-v32).

Procedures:

• When pointing to the Zenith, the PSF FWHM from DECam are compared to the CTIO DIMM seeing measurements according to the model FWHM^2 = DIMM^2 + \sigma^2. The best fit value is \sigma <= 0.55" across the full array. Therefore, we can measure the contribution of the PSF from the DECam by subtracting the DIMM seeing from the measured PSF by quadrature.
• Step 1: Point the telescope to zenith, take 10 exposures of 100 sec each in r, i and z band.
• Step 2: Measure the FWHM around bright stars after Flat-fielding and bias-subtraction
• Step 3: Get the DIMM FWHM from http://www.ctio.noao.edu/environ/environ.html and calculate the FWHM due to the DECam. The maximum of the sqrt(WFHM^2 - DIMM^2) should be less than 0.55". This is a check of TO.2.
• Step 4: Get the median of the FWHM and check whether it is less than 0.9" in r, i and z band.

Code availability:

In terms of the Gaussian Fit, the codes are available to measure the FWHM.

Question:

Here, the FWHM in the requriement is in terms of the Gaussian fit/weight or not?