Task #24772
Cavity 6 drive cable
Start date:
08/12/2020
Due date:
% Done:
100%
Estimated time:
Description
We found that the drive cable termination was bad at the LLRF rack. Also there was a small diameter jumper cable on the end of this cable going to the up converter. I don't ever want to see something like this done again on an accelerator.
Note that if you are ever working on one of these cables with an elbow you need to loosen up all connections, install and then tighten everything up. We are getting too much damage out here.
John and I put a new connector on and have varified that it is okay now. We did not have a heat gun so the heat shrink tubing is on the cable but needs to be hit with a heat gun.
History
#1 Updated by Daniel Klepec 5 months ago
- % Done changed from 0 to 100
- Status changed from New to Resolved
Heat shrink to the CAV 6 cable is complete.